Select a category to the left. Products can be viewed and added to a Paypal shopping cart on the right.
Click on "Policies" above for information about shipping.

The ProtoCard , Make your own SpinStudio peripheral modules! The ProtoCard gives you the ability to design and permanently solder together projects that can be easily unplugged when you want to work with a different project, then come back to it later, without having to start again from scratch. The ProtoCard gives you access to 8 of the Propeller IO lines, both I2C lines, 5 VDC, 3.3 VDC and VSS(ground). View Documentation Available now! Price $5.99 This solderless breadboard mounted Voltage Regulator Module supplies both 5 volt and 3.3 volt from a single wall transformer. A minimum 7 volt supply with a 2.1mm center positive barrel connector is needed to operate. Handy for prototyping circuits that require both 3.3 and 5 volt sources. This Regulator module plugs right into the end of your solderless breadboard and is compatible with most modern breadboards. View Documentation Available now! Price $12.50 This Serial 4x4 Keypad has a special backpack circuit board that translates key presses on the keypad, and outputs them as a serial stream. Compatible with both 3.3 and 5 volt devices, the serial stream is output at the same level as is fed to the module via VDD. Meaning....you feed it 3.3V, it will output the serial data at 3.3V levels. So no level shifting circuitry is required. Data is output at a fixed rate of 9600 baud. This product is assembled and tested before shipping. Plugs right into the SpinStudio IO / Servo module!!! Available now! Price $14.99